question about wiring ...

[Buncek]

hey !

i have a SD TB-6 humbucker and i have one push/pull pot and few SPDT switches ... on push pull i will do series/paralel wiring ... and i'd like to have a split coil too ... can it be done with this combination ?? cuzz i cant get DPDT(on/on/on) switch...

 

[hellraiser_666]

Wiring Diagram

maybe that, but it needs two push/pulls

 

[Buncek]

Wiring Diagram

maybe that, but it needs two push/pulls

yea that's a wiring for series/parallel ... bt i'm asking if i could ad one spdt switch on whic i could do split coil ??

 

[hellraiser_666]

Wiring Diagram

well then take off the push/pulls from the last one and add this "in between" the pots and the pickups.

if you are unsure of the color code on the second diagram, refer to this
Wiring Diagram

 

[Buncek]

Wiring Diagram

well then take off the push/pulls from the last one and add this "in between" the pots and the pickups.

if you are unsure of the color code on the second diagram, refer to this
Wiring Diagram

hmm i'll try to do it by this second schematic ... but i'm not sure if it will work cuzz it says something about two pickups and i have just one ...

 

[hellraiser_666]

The two pickup thing is for phase reversal, So if you are just doing normal phase, it will work fine

 

[Buncek]

what if i take this wiring and then solder one more wire in where is white wire soldered and take it to the switch and then from other end of switch go for ground ... would that work ??

 

[180gROC]

 

[hellraiser_666]

what if i take this wiring and then solder one more wire in where is white wire soldered and take it to the switch and then from other end of switch go for ground ... would that work ??

honestly man, i have no idea if that would work

 

[Buncek]

tnx for that !!

 

[AngryHatter]

Obviously, the only requirement of the pickup is that it is four conductor.