Question about velcro

[floyd84]

Ok, so I've got a Pedaltrain PT-2 that I've been outgrowing. I bought it new, a while back, and used the velcro that came with it. It's great stuff. I put the hook (hard) type on the board, and used the loop (fuzzy) on the pedals. I recently stumbled across a great deal on a PT-Pro with an ATA flight case, and snapped it up. However, the previous owner did the exact opposite. I got it with the loop (fuzzy) type all over it. I went to my local home center and bought a 15 foot roll of velcro brand "industrial strength" stuff, but it doesn't look to be as good as the Pedaltrain stuff. My questions are, has anyone used this or prefer it to the Pedaltrain velcro? Should I replace the fuzzy stuff on the new one with the industrial hook tape and keep my pedals as is? Or keep it as it is now and change the velcro on all my pedals?

 

[Beerdog80]

Unless your kicking your pedals, it shouldn't matter. I use real small strips and I've never had anything move or fall off

 

[floyd84]

I just wanna make sure when I pick up the board, the pedals don't flop off of it. The only ones I worry about moving during use are the wah and variphase

 

[floyd84]

Here's a pic of the smaller PT-2

 

[MATTM]

Nice board bro. I don't think it matters which side the hook and loop are on. The only pedal I'm concerned with on my Pedal Train is the wah since it's heavy. I just zip tied the base plate to the board.