Separate names with a comma.
Good diagram. I'll check this out tomorrow. Thanx a lot.
I am looking to wire my LP out of phase using this switch. Cam someone explain how to do it? i see a lot of lugs here and am not sure. I believe I...
ran a ground wire from the tone pot to the vole pot. Voile. Thank you so much. problem solved.
The jack is grounded to the tone pot. should i run a ground from the tone to the vol as well?
I ran an external wire from the TP to the vol pot. same hum when I touch strings.
OK, that's next.
jack is wired correctly, tip to hot, bare to ground.
Never thought about the jack wires. I'll check that now.
Not bare but connected from the TP grounded to the vol pot.
Bridge ground is correct, I just checked. Seems to be mostly from the volume pot. When i touch the tone pot it's OK. Could it ba a bad pot?
Turn the volume up a bit hum goes away even when I touch the strings.
Not that bad but terrible. String meaning from the bridge?
I have this LP Jr. project. I installed Seymour Duncan APH-1 set. I have a hum, but it gets worse when I touch the strings. Worse with the volume...