landsharkey

I'm preparing 2D plans for the LP carve top, with isolines and several cuts longitudinal, and that will be a real help. because there are "negative" areas around the top, next to the binding, that you can't see with isolines. I think that probably i can send you a 1:1 print on paper.

Hi
Take a look at my album, the isolines are almost ready

Hi Pat,
Take a look at Delcam Powershape-e
Top of 3d modelling sistem. I use it professiomaly, Powershape and Powermill.
Blender is the best for rendering with Yafray, both Open Source. In my gallery is a glass flute modelled in Powershape and rendered in Blender/Yafray

Hi,
Tomorrow I can make the isolines, I have to make the planes in 3D and intersect with the model. The model I have is for a lower angle of the neck, LP59.
DXF file? Illustrator?
Best,
Paulo

Hi,
did you asked me the isolines for the LP? I received a email from you but it was bloked by my server. If you did, i say that yes I can share the isoline. 5mm step?

Hi,
Of course. I have several plans. I send you a couple and if your inmail box can handle large files I can send som big files.

Thanks a lot

thanks for the PDF