You should check out the full on 22-Dual Master Setup with Serial Broadbucker setting. Pulling the bridge volume combines both buckers in serial and center switch is parallel. The bridge tone pulls a coil only if you pull the neck tone too but sounds good with in broadbucker mode too. the neck volume does dual sound for neck pup and when you have the neck coil tapped, it chooses the slugs or screws. I not sure which but the diagram is around here somewhere or you can find it and variations by searching for 22-Dual on google or something.
Tommy
Quote:
Originally Posted by MVendi81
Hey everybody,
I decided to attempt the coil tap & reverse phase wiring using the diagram from Guitarelectronics.com as a rough guide, except I wanted to have master volumes in the middle position, as well as be able to use the 50's-style wiring. I wondered if this was all possible while using DPDT push/pull pots, so...after some thought and consideration for some of the information I've learned here on this great forum I gave it a go...
I just finished the project and am proud to say it is a success! I also wanted to post my own diagram in case any of you wanted to try it...it's a great mod and of course gives you full use of your volume and tone controls. Just remember...you have to have at least 3-conductor wiring from your pickups to do this mod.
Cheers!
|